I have a calculated field in a report, which is as follows:
=IIf(IsNull([POI_E1A]),(([TodaysDate]-[EADDate])/365)/3,[A1]+[T2]+[A3]+[T4]+[A5]+[T6]+[A7]+[A8])
The calculation works fine; however, I only want to show the whole number (not rounded up; not rounded down). In other words, if the result is 0.9967, then I want 0 to appear.
I cannot figure out how to make this happen. In the properties section I ensured the format was "general number" with 0 decimal places but this didn't change the result. I tried changing the format in the calculated field, again, I wasn't successful.
Any help would be appreciated.
Trouble with Calculated Field (whole number)
=IIf(IsNull([POI_E1A]),(([TodaysDate]-[EADDate])/365)/3,[A1]+[T2]+[A3]+[T4]+[A5]+[T6]+[A7]+[A8])
The calculation works fine; however, I only want to show the whole number (not rounded up; not rounded down). In other words, if the result is 0.9967, then I want 0 to appear.
I cannot figure out how to make this happen. In the properties section I ensured the format was "general number" with 0 decimal places but this didn't change the result. I tried changing the format in the calculated field, again, I wasn't successful.
Any help would be appreciated.
0 commentaires:
Enregistrer un commentaire